Workers on scissor lifts must either be tied-off or protected by guardrails. The Aerial Lift standard (§1926.453) applies to equipment covered in ANSI A92. 2 (1969). Scissor lifts are not addressed in that ANSI standard; consequently, they are not covered by the Aerial Lift standard.
Does OSHA require you to wear a harness in a scissor lift?
Does OSHA Require Workers to Wear a Harness on a Scissor Lift? OSHA considers guardrails to be scissor lift fall protection. Assuming there’s an adequate guardrail system in place, scissor lift harnesses aren’t required by OSHA, but for all other situations, a personal fall restraint system is mandatory.
Do you need to be tied-off on a scissor lift?
Answer: No, neither §1926.451 or §1926.452(w) require employees to be tied-off when working from scissor lifts that have properly maintained guardrails.
At what height is a harness required on a scissor lift?
OSHA requires the use of fall protection equipment anytime a fall of 6 feet or more is possible on a construction site. Many construction contractors utilize scissor lifts for employees working at height. The first scissor lifts were built in the 1970s.
Is fall protection required when using a boom lift?
According to OSHA standard, employees must wear “a personal fall arrest or travel restraint system” when working from a boom lift. … This is because there is a significant risk of employees being ejected from these types of lifts.
Why you shouldn’t wear a harness in a scissor lift?
For instance, if a scissor lift operator is wearing a harness and goes over a lift’s guardrail, he or she could inadvertently create enough force to cause the machine to tip over. In this scenario, the operator could put himself or herself and bystanders in danger.
Can you use a ladder on a scissor lift?
Buckets, step stools, or ladders should never be used in a scissor lift as a way to gain extra height to reach work surfaces. … According to the Occupational Safety and Health Administration (OSHA), this usually rules out moving the lift in an elevated position.
Can you exit a scissor lift at height?
In particular, §1926.501(b)(1) requires fall protection at 6 feet above a lower level. A worker may enter or exit an aerial lift (at heights above 6 feet) provided that fall protection such as guardrails or a fall arrest system is used while the worker moves between the lift and the working surface.
Can anyone use a scissor lift?
Yes, you do. Scissor lifts can be dangerous and can cause accidents leading to personal injuries as well as structural and equipment damage. Current regulations state that all personnel who work with or near scissor lifts must be trained and licenced.
Can a scissor lift tip over?
Have you ever wondered, “Can a scissor lift fall over?” The answer is yes. In fact, a man lift tip-over is one of the most common aerial lift accidents.
What is the OSHA standard for fall protection?
OSHA requires that fall protection be provided at elevations of four feet in general industry workplaces, five feet in shipyards, six feet in the construction industry and eight feet in longshoring operations.
Do I need to wear a harness in a cherry picker?
The person operating the cherry picker should wear a fall arrest system, usually consisting of; a full-body harness, a lanyard and a suitable anchor point on the cherry picker’s basket.
What is the correct stopping distance when traveling on a scissor lift?
A: The length of time required to stop a forklift traveling at full speed varies based on the lift, its load, and other factors. Generally, forklift operators should maintain a distance of at least 20 ft.
Can a manlift be moved while the basket is raised?
An aerial lift truck shall not be moved when the boom is elevated in a working position with men in the basket, except for equipment which is specifically designed for this type of operation in accordance with the provisions of paragraphs (a)(1) and (2) of this section.
Do you need to wear a harness in a bucket truck?
If they could fall farther than two feet, a full body harness and lanyard are required. In a practical sense if you restrict the employees fall to two feet, then their lanyard cannot be more than two feet long. This would seriously restrict movement in the bucket, which is not always feasible.