Buckets, step stools, or ladders should never be used in a scissor lift as a way to gain extra height to reach work surfaces. … According to the Occupational Safety and Health Administration (OSHA), this usually rules out moving the lift in an elevated position.
Can you climb out of a scissor lift?
Answer: OSHA standards do not prohibit employees from exiting or entering an aerial lift basket that rests on or adjacent to an elevated surface. Section 1926.453(b)(2)(v) requires that employees working from aerial lifts be tied-off.
Do you have to be tied-off in a scissor lift?
Workers on scissor lifts must either be tied-off or protected by guardrails. The Aerial Lift standard (§1926.453) applies to equipment covered in ANSI A92. 2 (1969). Scissor lifts are not addressed in that ANSI standard; consequently, they are not covered by the Aerial Lift standard.
Can I move a scissor lift while elevated?
Some safe work practices to ensure safe, stable conditions for scissor lift use include: Follow the manufacturer’s instructions for safe movement—this usually rules out moving the lift in an elevated position. … Use the scissor lift outside only when weather conditions are good.
Can you use a scissor lift as an anchor point?
The guardrails are enough to protect the employee from a fall hazard. … Regardless, some scissor lifts have anchor points so that employees can properly use fall protection if desired. It’s not required. But, employees can choose to wear it so long as the lift has an ANSI-rated anchor point.
Why you shouldn’t wear a harness in a scissor lift?
For instance, if a scissor lift operator is wearing a harness and goes over a lift’s guardrail, he or she could inadvertently create enough force to cause the machine to tip over. In this scenario, the operator could put himself or herself and bystanders in danger.
What is the OSHA standard for scissor lifts?
While there are no OSHA provisions that specifically address scissor lifts, they do meet the definition of a scaffold (§1926.451 – general requirements for scaffolds). Employers must therefore comply with the other applicable provisions of Subpart L when using scissor lifts.
Can anyone use a scissor lift?
Yes, you do. Scissor lifts can be dangerous and can cause accidents leading to personal injuries as well as structural and equipment damage. Current regulations state that all personnel who work with or near scissor lifts must be trained and licenced.
How high will a scissor lift go?
Depending on the model, expect a scissor lift to extend from ten to sixty feet. However, most scissor lifts have working heights that range from 20 to 40 feet. Scissor lifts tend to have less vertical elevation than other types of aerial lifts.
At what height do you need a harness?
OSHA requires that fall protection be provided at elevations of four feet in general industry workplaces, five feet in shipyards, six feet in the construction industry and eight feet in longshoring operations.
Why do scissor lifts wobble?
The higher a platform is raised, the more unstable the lift structure becomes. This increases wobbling caused by movement on the mobile elevating work platform (MEWP). … The extra weight acts as a force on the end of a lever, and extending the scissor lift increases the force, making the lift unstable.
What is the correct stopping distance when traveling on a scissor lift?
A: The length of time required to stop a forklift traveling at full speed varies based on the lift, its load, and other factors. Generally, forklift operators should maintain a distance of at least 20 ft.
How do you transport a scissor lift?
The best way to ship your construction lift is by calling Heavy Haulers. Our logistics professionals can help you handle moving any type of construction equipment. Scissor lifts usually require step deck or flatbed trailers as they offer more clearance for travel on an American freeway.
Does Cal OSHA require harness on scissor lift?
Cal/OSHA reminds employers that there are two exceptions under which personal fall protection is required. tight space, then Section 3642 (a) applies and requires workers on the scissor lift to use personal fall protection equipment until the guardrails are restored.
Where is the anchor point on a scissor lift?
Anchor points are provided on the platform floor of the scissor lift for this purpose.
Do you need to wear a harness in a man basket?
From personal experience the answer to your question will always be wear the harness and make sure that it is full body harness with the lanyard attached to a secure point in the basket. Some will argue that only a life jacket and that full body harness is not required when working over water.