Scissor lifts must have guardrails installed to prevent workers from falling (see 29 CFR 1926.451(g) or 29 CFR 1910.29(a)(3)(vii)). Employers should train workers to: Check to see that a guardrail system is in place before working on the scissor lift.
Do you need a safety harness on a scissor lift?
While OSHA does not require scissor lift workers to wear a harness or other PFRS, that doesn’t mean you shouldn’t. After all, there are many hazards associated with scissor lift use. That’s one reason OSHA requires scissor lifts to have guardrail systems.
Is fall protection required on aerial lifts?
Employers must ensure that employees using personal fall arrest systems while working on aerial lifts at heights six feet or more above a lower level comply with §1926.502(d) of subpart M, specifically: … Use of a body harness with a lanyard (fall arrest system).
Can a scissor lift fall over?
Have you ever wondered, “Can a scissor lift fall over?” The answer is yes. In fact, a man lift tip-over is one of the most common aerial lift accidents.
Can a scissor lift be used as edge protection?
Use a suitable working platform such as scaffolding, boom lifts or scissor lifts. Provide adequate edge protection by using jump screens, scaffolding or guardrails – ensuring ALL components are in place. … You should consider whether a platform ladder, elevating work platform or scaffolding could be used instead.
At what height is a harness required on a scissor lift?
OSHA requires the use of fall protection equipment anytime a fall of 6 feet or more is possible on a construction site. Many construction contractors utilize scissor lifts for employees working at height. The first scissor lifts were built in the 1970s.
What is the OSHA standard for fall protection?
OSHA requires that fall protection be provided at elevations of four feet in general industry workplaces, five feet in shipyards, six feet in the construction industry and eight feet in longshoring operations.
Do I need a harness in a boom lift?
“All occupants of the aerial platform shall wear a fall arrest system. … The fall arrest system shall include a full body harness and a lanyard arranged so that in the event of a fall, the forces are applied to the worker shall not exceed 6-N (1350 lbf).”
Are scissor lifts safe?
Scissor lifts provide a safe and reliable platform for workers to perform job tasks when used according to the manufacturer’s instructions. When not used properly, scissor lifts can present a serious hazard to workers. Employers are responsible for keeping workers safe.
Can anyone operate a scissor lift?
Yes, you do. Scissor lifts can be dangerous and can cause accidents leading to personal injuries as well as structural and equipment damage. Current regulations state that all personnel who work with or near scissor lifts must be trained and licenced.
Do scissor lifts sway?
This study demonstrated that ground impact forces and postural sway were significantly affected by scissor lift opening type, horizontal and vertical distances between the lift surface and the work surface, the slope of the work surface, and methods of adjusting the body while ingress or egress the lift.
How close can you work to an unprotected edge?
A common rule of thumb in the construction industry is “the 6-foot rule,” i.e., that a worker on a flat surface more than 6 feet from an unprotected edge does not require fall protection.
How stable is a scissor lift?
The study found that the scissor lift was stable at all heights up to at least 300 pounds of applied side force. … During the curb tests, the scissor lift was driven at maximum forward and reverse speeds on a flat, level surface.
How often do you need scissor lift training?
OSHA requires all lift workers to be recertified every three years.