Why does my ride on mower cut out when I engage the blades?

If a pulley doesn’t spin freely, it can cause the engine to die when the blades are engaged. … The pulleys in your lawn tractor are driven by the drive belt, and turn the spindles. If a pulley doesn’t spin freely, it can cause the engine to die when the blades are engaged.

Why does my ride on mower keep cutting out?

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. … This sticky fuel can clog up the carburetor and cause the engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner.

Why does my lawn mower only run for a few seconds then dies?

If your lawn mower starts, runs briefly, then dies these are the four most common reasons that’s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.

Why is my mower hesitating?

A dirty air filter is one of the most common causes of a poorly running lawn mower, since it starves the engine of the oxygen needed for combustion. Fuel Filter: Check the fuel filter on the mower to make sure it’s clean, and replace it if needed.

THIS IS INTERESTING:  Will rain ruin a push mower?

What does a PTO switch do?

The PTO is a switch or lever found on tractors and mowers and stands for Power Take Off. This can be an electric switch or mechanical engagement that takes engine power to operate the mower deck or an implement. The PTO can run mowers by either a belt or a shaft.

How do I know if my electric PTO clutch is bad?

Activate the PTO engagement lever, then disengage it. Turn it on and off several times. If you do not hear a disengagement noise or see the power takeoff pulley stopping or slowing down at any time, it indicates the clutch and plates have galled together from excessive heat, or the slip ring has jammed.

Why does my lawnmower start and shut off right away?

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. … This sticky fuel can clog up the carburetor and cause the engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner.

How do you clean a carburetor on a lawn mower without removing it?

However, you can not spray the carburetor when the engine is off since it cannot do the cleaning without being propelled. All you need to do is to start the engine and spray directly at the center of the carburetor while it is running. Any deposits clogging in the carburetor will easily be removed.

Why does my lawn mower start but not stay running?

A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won’t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug.

THIS IS INTERESTING:  What is the difference between styled and unstyled John Deere?

Why does a lawn mower run rich?

A restricted air filter will cause an engine to run too rich. Remove the filter and check it then. If you have to prime the engine first to get it started, it could also be the float stuck. In the case of a diaphram carb, it could be the needle is stuck in the open position.

Why does my mower have a rough idle?

Common solutions for: Lawn mower runs rough

The carburetor might be clogged. … If the carburetor is clogged, try cleaning it with carburetor cleaner. If cleaning the carburetor isn’t effective, rebuild or replace the entire carburetor.

How do you adjust a carburetor on a lawn mower?

Set the throttle to fast and start the mower engine. Turn the high speed screw first clockwise until the engine slows, then counterclockwise until it slows. Locate the center point where the engine idles best. Move the throttle from slow to fast then back to slow to test the adjustment.

Special equipment and operation