Your question: How do you turn off the Rio on a John Deere lawn mower?

Look up under the dash of the John Deere mower, beside the steering column, for the RIO switch and wire. Grip the connector on the end of the wire and pull it straight out to disconnect if from the back of the RIO switch.

What is Rio on John Deere?

Reverse Implement Option (RIO) allows operator to mow while backing up if deemed necessary. Mowing while backing up is strongly discouraged. … The next time the operator chooses to keep the mower engaged while backing up, they must repeat this procedure.

How do you turn off the reverse safety on a John Deere riding lawn mower?

Locate the reverse safety switch near the same side as the battery on your John Deere mower. There will be a plastic wire harness with wires. Grasp the wire harness and press down on the side tabs with your thumbs then pull them apart to unplug it.

Where is the PTO switch on a John Deere mower?

Most John Deere lawn mowers are equipped with an electric PTO (Power Take Off). The PTO is the mechanism that turns on the blades located under the mower deck. The PTO works off of a 12-volt system. The electric clutch is operated by a switch located on the dashboard of the lawn mower.

THIS IS INTERESTING:  How do I know if my riding mower engine is seized?

Where is bypass rod on John Deere?

On the D140 and other “Automatic Models”, Deere calls this the “Bypass Valve Lever”, which is the small metal rod which stick out of the back of the tractor and has a 90 degree bend on the end of it. It is referred to on page 22 of the Operators manual and other places in the same manual.

Can John Deere mow in reverse?

The John Deere LA115 lawn mower has an automatic transmission and can travel in reverse at a maximum speed of 3.2 miles per hour. The LA115 includes a safety control called a Reverse Implement Option (RIO), which shuts down the engine and mower blade if you attempt reversing with the blade engaged while mowing.

What is Rio on tractor?

The RIO is short for Reverse Implement Operation and is a standard safety feature on riding lawn mowers. This mechanism may be a button, lever, or key switch and must be engaged at the initial onset of reverse mowing or else the mower deck or engine will shut down.

Why won’t my mower blades engage?

Belt-the number one cause for your blades not to engage is that your belt is either stretched or loose causing it to slip or fall off completely. Belt could have snapped also. When you are trying to process too much grass/leaves they could pack up under your deck and push off your belt.

Why did my mower blades stop working?

If your mower blades will not turn after the blade controls have been engaged, your deck belt may be broken. … Clean out any debris or grass that may have built up above the mower deck, and remove any guards or covers that protect the deck belt system. Once the belt can be accessed, inspect it for any damage or wear.

THIS IS INTERESTING:  What size battery does my riding mower need?

Why does my John Deere riding mower dies when I engage the blades?

If a pulley doesn’t spin freely, it can cause the engine to die when the blades are engaged. … The pulleys in your lawn tractor are driven by the drive belt, and turn the spindles. If a pulley doesn’t spin freely, it can cause the engine to die when the blades are engaged.

How do you turn off a John Deere lawn mower?

Stopping

  1. Step 1: Run the engine at high throttle without any load for a few seconds.
  2. Step 2: Turn the key to the stop position.
  3. Step 3: Remove the key.
  4. Step 4: Set the parking brake.

14.07.2016

Special equipment and operation